Cisco路由器口令的恢复(cs500)

王朝other·作者佚名  2008-05-31
窄屏简体版  字體: |||超大  

Description

This document describes how to recover a passWord on a Cisco cs500 communication server.

The Cisco cs500 does not have a console port so to recover a password you must erase the configuration then configure the server again.

Step-by-Step Procedure

1.Unplug the Cisco cs500 server.

2.Press and hold the DEFAULT button on the front of the chassis.

3.Turn on the server.

The OK and LAN LEDs blink on and off.

4.When the OK and LAN LEDs blink off (after about 15 seconds), release the DEFAULT button.

The 500-CS enters setup mode in about two to ten minutes.

5.Configure the server.

 
 
 
免责声明:本文为网络用户发布,其观点仅代表作者个人观点,与本站无关,本站仅提供信息存储服务。文中陈述内容未经本站证实,其真实性、完整性、及时性本站不作任何保证或承诺,请读者仅作参考,并请自行核实相关内容。
 
 
© 2005- 王朝網路 版權所有 導航