信道化E1 简单配置

王朝other·作者佚名  2008-05-31
窄屏简体版  字體: |||超大  

Router# configure terminal

Router(config)# controller e1 1/1/0

Router(config-controll)# channel-group 20 timeslot 1-5, 20-23

Router(config-controll)# channel-group 21 timeslot 6-19

Router(config-controll)# interface serial 1/1/0:20

Router(config-if)# ip address 10.20.30.1 255.255.255.0

Router(config-if)# interface serial 1/1/0:21

Router(config-if)# ip address 10.20.40.1 255.255.255.0

Router# show interface serial 3/0:30

Serial3/0:30 is up, line PRotocol is up (looped)

Hardware is Multichannel E1

MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec, rely 255/255, load 1/255

Encapsulation HDLC, CRC 16, Data non-inverted, keepalive set (10 sec)

Last input 00:00:08, output 00:00:08, output hang never

Last clearing of “show interface” counters 00:00:27

Input queue: 0/75/0 (size/max/drops); Total output drops: 0

Queueing strategy: weighted fair

Output queue: 0/64/0 (size/threshold/drops)

Conversations 0/1 (active/max active)

Reserved Conversations 0/0 (allocated/max allocated)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

2 packets input, 48 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

2 packets output, 48 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffers copied, 0 interrupts, 0 failures

0 carrier transitions

no alarm present

Timeslot(s) Used:31, subrate: 64Kb/s, transmit delay is 0 flags

这是打环测试

 
 
 
免责声明:本文为网络用户发布,其观点仅代表作者个人观点,与本站无关,本站仅提供信息存储服务。文中陈述内容未经本站证实,其真实性、完整性、及时性本站不作任何保证或承诺,请读者仅作参考,并请自行核实相关内容。
 
 
© 2005- 王朝網路 版權所有 導航