RFC1897 - IPv6 Testing Address Allocation

王朝other·作者佚名  2008-05-31
窄屏简体版  字體: |||超大  

Network Working Group R. Hinden

Request for Comments: 1897 Ipsilon Networks

Category: EXPerimental J. Postel

ISI

January 1996

IPv6 Testing Address Allocation

Status of this Memo

This document specifies an Experimental protocol for the Internet

community. This memo does not specify an Internet standard of any

kind. Discussion and suggestions for improvement are requested.

Distribution of this memo is unlimited.

1.0 IntrodUCtion

This document describes an allocation plan for IPv6 addresses to be

used in testing IPv6 prototype software. These addresses are

temporary and will be reclaimed in the future. Any IPv6 system using

these addresses will have to renumber at some time in the future.

These addresses will not to be routable in the Internet other than

for IPv6 testing.

The addresses described in this document are consistent with the IPv6

Addressing Architecture [ARCH]. They may be assigned to nodes

manually, with IPv6 Auto Address Allocation [AUTO], or with DHCP for

IPv6 [DHCPv6].

2.0 Address Format

The address format for the IPv6 test address is consistent with the

provider-based unicast address allocation [PRVD] which is as follows:

3 5 bits 16 bits 8 24 bits 8 64 bits

+---+----------+----------+---+------------+---+----------------+

010RegistryIDProviderIDRESSubscriberIDRESIntra-Subscriber

+---+----------+----------+---+------------+---+----------------+

The specific allocation of each field of the test address format is

as follows:

3 5 bits 16 bits 8 24 bits 8 16 bits48 bits

+---+----------+----------+---+------------+---+--------+-------+

Autonomous IPv4 Subnet Intf.

010 11111 System RES Network RES

Number Address Address ID

+---+----------+----------+---+------------+---+--------+-------+

where:

010

This is the Format Prefix used to identify provider-based

unicast addresses.

11111

This is a Registry ID reserved by the IANA. The initial use of

addresses in this Registry ID for IPv6 testing is temporary.

All users of these addresses will be required to renumber at

some time in the future.

Autonomous System Number

This is the current autonomous system number assigned to the

provider providing internet service to the an IPv6 testers

organization. For example for IPv6 testers receiving internet

service from BBN Barrnet would use autonomous system number 189.

This would be coded in the autonomous system field of the

address as follows:

0000 0000 1011 1101 (binary)

The values for the autonomous system number of an organization's

provider can be oBTained from that provider, or can be looked up

in the "whois" database maintained by the internic.net.

RES

This field is reserved and must be set to zero.

IPv4 Network Address

This is based on the current IPv4 routable address for the

subscriber which the interface is connected. It is formed by

taking the high order 24 bits of the IPv4 address. For example

for an IPv4 address (in IPv4 syntax):

IPv4 Address

------------

39.11.22.1

the value to put in this field of IPv6 address is:

IPv4 Format Hex

------------ ------

39.11.22 270B16

This technique for generating values for this field only works

for subscribers which have IPv4 subscriber prefixes less than

equal to 24 bits long. There may be subscribers using IPv4

addresses with longer subscriber prefixes, but this conflict is

expected to be very rare. Subscribers with subscriber prefixes

larger than 24 bits should use the remaining bits in the IPv4

prefix as the high order bits in the Subnet Address field.

RES

This field is reserved and must be set to zero.

Subnet Address

The Subnet ID identifies a specific physical link on which the

interface is located. There can be multiple subnets on the same

physical link. A specific subnet can not span multiple physical

links. The assignment of values for this field is left to an

individual subscriber. One possible algorithm to generate

values for this field is to use the bits in the IPv4 address

which identify the IPv4 subnet.

Interface ID

This is the unique identifier of the interface on the link,

usually the 48-bit IEEE 802 MAC address of the interface if

available.

4.0 References

[ARCH] Hinden, R., and S. Deering, Editors, "IP Version 6

Addressing Architecture", RFC1884, Ipsilon Networks, Xerox

PARC, December 1995.

[AUTO] Thomson, S., "IPv6 Stateless Address Autoconfiguration",

Work in Progress.

[DHCP6] Bound, J., "Host Configuration Protocol for IPv6", Work

in Progress.

[PROV] Rekhter, Y., and P. Lothberg, "An IPv6 Provider-Based

Unicast Address Format", Work in Progress.

5.0 Security Considerations

Security issues are not discussed in this memo.

6.0 Authors' Addresses

Robert M. Hinden

Ipsilon Networks, Inc.

2191 E. Bayshore Road, Suite 100

Palo Alto, CA 94303

USA

Phone: +1 415 846 4604

Fax: +1 415 855 1414

EMail: hinden@ipsilon.com

Jon Postel

Information Sciences Institute

4676 Admiralty Way

Marina del Rey, CA 90292-6695

USA

Phone: +1 310 822 1511

Fax: +1 310 823 6714

 
 
 
免责声明:本文为网络用户发布,其观点仅代表作者个人观点,与本站无关,本站仅提供信息存储服务。文中陈述内容未经本站证实,其真实性、完整性、及时性本站不作任何保证或承诺,请读者仅作参考,并请自行核实相关内容。
 
 
© 2005- 王朝網路 版權所有 導航