例子：SIP通过网关的呼叫PSTN

例子：SIP通过网关的呼叫PSTN

例子：SIP通过网关的呼叫PSTN SIP to PSTN Call Through GatewayTo header. The caller may have dialed either the globalized phone number 1-202-555-1313 or they may have just dialed a local number 555-1313, and the SIP phone added the assumed country code and area code to produce the globalized URI. The SIP phone has been preconfigured with the IP address of the PSTN gateway, so it is able to send the INVITE directly to gw.carrier.com. The gateway initiates the call into the PSTN by selecting an SS7 ISUP trunk to the next telephone switch in the PSTN. The dialed digits from the INVITE are mapped into the ISUP IAM. The ISUP Address Complete Message (ACM) is sent back by the PSTN to indicate that the trunk has been seized. Progress tones are generated in the one-way audio path established in the PSTN. In this example, ring tone is generated by the far end telephone switch. The gateway maps the ACM to the 183 Session Progress response containing SDP indicating the RTP port that the gateway will bridge the audio from the PSTN. Upon reception of the 183, the caller's UAC begins receiving the RTP packets sent from the gateway and presents the audio to the caller so they know that the call is progressing in the PSTN.

SIP to PSTN call through gateway. 200 OK response to the caller. Because the RTP media path is already established, the gateway echoes the SDP in the 183 but causes no changes to the RTP connection. The UAC sends an ACK to complete the SIP signaling exchange. Because there is no equivalent message in ISUP, the gateway absorbs the ACK.

BYE to the gateway. The gateway maps the BYE to the ISUP Release message or REL. The gateway sends the 200 OK to the BYE and receives a RLC from the PSTN. These two messages have no dependency on each other; if, for some reason, either the SIP or PSTN network does not respond properly, one does not want resources held in the other network as a result.